This Post Processor supports a 3-Axis Mill or Router powered by WinPC-NC control software. Below is a sample of the ISO g-code:

%
(0045)
G71
(WinPC-NC XYZ MACHINE)
(POST VERSION: 051525-1)
(POSTED DATE: 5/30/2025  TIME: 11:56:08 PM)

(T1  D=6.35 CR=0. - 1/4" FLAT 3FL)
(T7  D=9.525 CR=0. - 3/8" FLAT 3FL)
(T6  D=12.7 TAPER=135.DEG - 1/2 SPOT DRILL 135 CARBIDE)
(T4  D=6.35 TAPER=135.DEG - 1/4" DRILL 135)
(T9  D=4.0386 TAPER=135.DEG - #21 DRILL 135 COBALT)

(TOTAL MACHINING TIME = 0:01:13)
(SET G54 AT TOP CENTER OF BLOCK)

(FIN ROUND POCKET)
N1 M05
N2 T1 M06
N3 G17 G54 G80 G90 G94
N4 G00 X-.8926 Y1.3128 S3000 M03
N5 Z1.2865
N6 G94 G01 X-1.2877 Y.9284 Z1.2382 F203.200
N7 X-1.5276 Y.432 Z1.19
N8 X-1.5832 Y-.1166 Z1.1418
N9 X-1.4479 Y-.651 Z1.0935
N10 X-1.1379 Y-1.107 Z1.0453