Last week I was asked to install the newest (free) version of Draftsight (V1R5.2). So I did.

When I started working on a drawing I experienced the following problem (I didn't have to problem with the previous version):

When selecting a dimension to edit/move, the performance of Draftsight instantaneously gets very slow. It's almost impossible to pan or zoom at that moment. When unselecting the dimension (by hitting 'ESC') the problem is over instantaneously.

Anybody else experiencing this problem? I don't have to explain that this is very annoying.

I hope engineers from Draftsight are reading this message too so than can fix this. :-)