Electrode machining - split offsets for XY and Z

Hi,

Is it possible in the DELMIA system to split the machining allowance between the XY axes (radial) and the Z axis (axial)? This is necessary for the production of graphite or copper electrodes. This method is used to accurately account for the spark gap (undersize). I tested the "Offset Group" option, but it is not suitable, as it results in sharp transitions.

Best regards

Petr

Answers 8
DG
DG 2026-10-05

Hello Petr, currently the offset capability is constant across the part in the design tool, such enhancement is under investigation by the development team. For the time being the meyhodology is to use offet group in the programming environment.

DG
DG 2026-10-05

Here is more information about it 

DG
DG 2026-10-05

Hello Petr, if offset groups as mentioned does not satisfy your case , can you share it with us so we could have a look and propose an alternative. You can write to me here : dgw@3ds.com. Thank you

PS
PS 2026-10-05

Hello,

Thank you for your response.

The Offset Group does not create a smooth transition between an allowance of 0.0 mm and an allowance of -0.5 mm.

I am attaching images showing the machining of the sphere. They show the ideal result for machining with an allowance of Z 0.0 mm and XY -0.5 mm. A smooth transition is achieved in this case.

Best regards,
Petr 

comment imagecomment imagecomment imagecomment imagecomment imagecomment image
JH
JH 2026-10-05

The spark gap is uniform between the workpiece and the electrode. Do you mean you want zero off set on the setting frame? That is a common need but I have never heard of a different offset between XY and different for Z

JM
JM 2026-10-05

Hello,
I have also come across a requirement from customers machining automotive sheet-metal stamping dies to have a continuous variation of the offset depending on the surface inclination, or at least on the inclination of the toolpath.

Offset groups do not solve this requirement, as they do not provide a continuous transition over the entire range. In practice, this cannot be achieved by remodeling the surfaces either, because the surfaces are usually far too complex for such an approach. Some CAM systems are already capable of providing this kind of continuous transition.

PS
PS 2026-10-06

Hello,

Thank you for your answers.

Yes, a constant spark gap is normally used. However, there are different ways of moving the electrode, such as direct movement in the Z-axis, orbital movement, and 3D orbital movement. In some cases, it is also necessary to use different stock allowances on the top and side surfaces of the electrode.

CAM systems such as CAMWorks, SURFCAM, and HSMWorks allow these allowances to be set independently.

It is of course possible to achieve different allowances without having separate allowance settings in the CAM system. To create the required surface, the finishing toolpath can be programmed with a tool size that is smaller by the value of the spark gap than the actual tool used on the machine.

For example, in the CAM system I can define a tool with a diameter of D1.8 / R0.9 and a stock allowance of 0.0 mm, while using a D2 / R1 tool on the machine. This makes it possible to achieve the required difference in allowance while also creating a smooth transition between the individual surfaces.

For this reason, I believe it would be useful to add the possibility of setting separate allowances for the top and side surfaces of the electrode. This functionality would significantly simplify electrode programming and make it easier to handle cases where different spark gaps are required in different directions.

Best regards
Petr

DS
DS 2026-10-06

Hi Petr. I used to machine electrodes for sinker edms. I understand what you are asking for, especially when trying to accommodate certain orbit patterns and spark gaps that can vary based on direction and detail. I’m not familiar with our CAD enough to know if we have a solution out of the box. @DG I can explain if needed.