I am trying to route multiple wires into a single origin / destination to clean up my schematic. They are ground wires so there are a lot. When I do this an additional wire is always added on one end of the circuit. When I manually edit the wire order it is correct if I delete the additional wire and shows like I would if I wired manually. When I enter the dialog for editing the wire order the wire is always added back in for all origins so I need to reedit every equipotential point every time. Is there a way to lock a equipotential point from being edited. this seems very broken. The origin / destination should not change the way wiring works if the wire ordering is set.

Thanks,

Woody

Edu ​​​​​​​