Thanks to the fablab team, I now have a Porsche ;-)

In december, Fred Vacher posted the .stl file of the Porsche Cayman, and here are the prints.

The .stl file is quite big so it takes a few minutes to generate the .cube, but it works fine.We tried twice to print the car to the maximum size, and both times we had the same (minor) issue, on the same spot: on the front left wheel, the glue did not avoid the thermo-mecanical deformations (Cube 1 printer was used).

When printing the car in a smaller size (70% or 50%), the problem dissapears.

Thanks!!