Tesla's Bladeless Turbine

Technical Brief

Purpose and operating principle

Reconstruct the disk turbine using the supplied assembly drawing, photographs and US 1,061,206. The rotor consists of parallel, closely spaced disks fixed to a shaft. Pressurized fluid enters near the disk periphery with a tangential velocity component. Viscous shear transfers angular momentum from the moving fluid to the disk surfaces, producing shaft torque without rotor blades. The fluid follows inward spiral paths and leaves through openings near the shaft and the central exhaust passages.

Main components to model

Rotor assembly: flat disks, central exhaust openings and connecting spokes, shaft, spacers, shoulder and retaining hardware. Model one disk and use a linear pattern to create the stack.

Casing: peripheral chamber, end covers, inlet passage or nozzle, central exhaust duct, flange holes and supporting feet. 

Shaft support: bearings or bearing housings, shaft seals and visible fittings. Use the assembly drawing for concealed geometry and photographs for external form. Preserve radial, axial and interdisk clearances.

Flow path and power transfer

The working fluid supplies the energy. Its tangential speed relative to the disk surfaces creates shear; the resulting torque drives the rotor and its external load. Disk spacing, active surface area, inlet geometry and operating conditions strongly affect performance. Do not adopt a universal optimum gap or an efficiency value from appearance alone. In turbine operation the flow is from the periphery toward the center; shaft driven pump operation reverses the energy transfer and generally uses outward flow.

Useful relationships: shaft power P = T omega, with torque T in N m and angular speed omega = 2 pi n / 60 in rad/s for n in rpm. If, as a declared modeling assumption, 9 inches denotes disk diameter, D = 228.6 mm and disk rim speed is u = pi D n / 60 with D expressed in meters. The package title alone does not establish this dimension.

Suggested simulation sequence

First build a parametric assembly, section view and exploded view, checking the complete inlet to exhaust path.

 For optional CFD, include the actual fluid gaps and inlet geometry, impose declared inlet and outlet conditions and use a rotating wall or rotating domain method supported by the solver. 

Refine the mesh across the gaps and near disk surfaces. 

Calculate surface shear torque, pressure, flow and shaft power at stated speeds. Couple torque to rotor inertia and load only if startup is investigated. 

A flow animation alone does not validate output or efficiency.

Sources and reconstruction limits

US 1,061,206, Turbine (6 May 1913), establishes the principle and a representative construction. The supplied Tesla Turbine assembly drawing, sheet 147, shows plan, end and sectional views; photograph markings include MNT, VI / III, 42 and 43. These sources are complementary, but identical internal construction is not established. The book excerpt (WIRELESS Life Work and Doctrine of Nikola Tesla, pp. 231 and 234) provides historical context on development and testing; its reported results are not ratings for this unit. The small MA006-03-041A image has limited detail. Verify legible drawing dimensions before scaling; otherwise label disk count, gap, thickness, materials, inlet conditions and speed as assumptions.




Historical Sources

 

 

 

 

Visual References

 

 

 


 

Disclaimer: The documentation provided by the Nikola Tesla Museum is intended exclusively for registered participants in the Open Tesla Challenge, for use within the competition. It may not be redistributed, published, or used for other purposes without the Museum’s prior written consent.

Comments 0