Where did my model go?

I was adding some holes to a model, and it disappeared.

If I select the "Boss-Extrude1" I see the wire frame, just no model.

What the heck did I do? 😁 

Answers 6
DZ
DZ 2025-01-10 Best Answer

You hid it! 🫣 I see it! Click the show button. You also have the part transparent.

(edited to add the words "the part" to the above statement).

comment imagecomment imagecomment imagecomment image
SC
SC 2025-01-10

tab button?

KC
KC 2025-01-13

SW has two default keyboard shortcuts: TAB and Shift+TAB.
TAB, if tapped (deliberately or by oops) while the cursor is over a displayed part/body, that part/body becomes hidden.
Shift+TAB, if tapped (deliberately or by oops) while the cursor is over a hidden part/body, that part/body becomes displayed.

If you don't want these, right click Command Manager and select Customize. Then on the Customize dialog, click the Keyboard page.
Search for these two shortcuts and remove their key assignments.

After any UI mods, run the Save/Restore Settings utility to write out your settings for future recall, if needed.
Accessible via the System Options gear flyout, the Tools menu or from the SW#### Tools Start menu.

DZ
DZ 2025-01-10

@SC Yep I was just fixing to come back on here & mention the Tab Button. 

When you have your cursor over a body & you press the Tab Key it will "hide" the body. When you have the cursor over a hidden body & you hold the Shift Key & then press the Tab Key it will "show" the hidden body.

DM
DM 2025-01-10

When the model disappears try the good old undo button!  I usually blame 99% of my graphic problems from the uncertifiable video card that comes with the computers. Some of the things I have seen today working remote for the first time.  
I usually go for the rebuild, then think about the undo after it is to late.  Then have to figure out what happened to the model.  Sometimes it is best to close without saving an picking up from your last save. 

RS
RS 2025-01-13

Thank you for all the replies!