Weld lengths still not correct

Hi,

I thought that this was going to be resolved in 2017, but looks like it is still an issue.

When using the Weld Bead function if I have a 6mm fillet weld on one side of a 1000mm plate looking at the properties I see a weld length of 1000mm. this assumes that a 6mm can be done in one pass.

However if I have a 15mm fillet, I cannot weld this in one pass. It may take 4 passes to achieve the 15mm fillet.

So I put 4 passes into the box, but the total weld length still shows 1000mm.

Shouldn't the total weld length be number of passes x initial weld length = 4 x 1000 = 4000mm of weld laid?

Thanks

Mark )SolidWorks 2017 sp0)

SolidworksDrawings And Detailing