using pattern to copy out a circular feature

I have a circular cut in a board and I would like to repeat the circular feature out parallel like I have the lines in the same file but I can't work out if it can be done without doing it in the sketch. I have attached the file.

Thanks

SolidworksParts And Features
Answers 4
GH
GH 2012-07-11 Best Answer

Is this the same problem as you have already posted about?

BH
BH 2012-07-11

Doing the tutorials on patterns would be a good start

SF
SF 2012-07-11

this is not the same problem I have already posted, and I have done the course but none of it covers patterning in a manner I have described

BH
BH 2012-07-11

perhaps you could ellaborate on what you're after in regards to repeating a circular pattern out parallel.