Using Configurations with Sketched Bend

I have a simple sheet metal part that has a 88deg bend.  I created it using a flat pattern and Sketched Bend at 88deg.  I want to use a Configuration to show it in the installed state at 90deg.  I tried to do this with adding Manual Configuration and then modifying the angle in the Sketched Bend feature.  This did changed both configurations (default, and as installed).  Sketched Bend does not have an option for "this configuration only".

Any ideas on how I can do this?

Thanks

- Derek

SolidworksSheet Metal
Answers 5
WS
WS 2017-05-16 Best Answer

The default config is 88 degrees.  The 90 degree config is 90 degrees.

DK
DK 2017-05-16

Wayne - Thanks for the quick reply.  I am not able to open.  I have SW 2014 - is this newer version?

Thanks

NH
NH 2017-05-17

Add config and double click sketch bend, then double click angle dim change to this config and change dim.

comment imagecomment image
DK
DK 2017-05-17

Ned - Thanks for the pic.  I got it to work.

  • One thing to add to your instructions...  after you modify the dimension in step 3) and click the green checkmark, you need to go to the left side and under Primary Value... Configurations...  select the "This Configuration" option.
  • And for each of the other configurations you have change the dimension property to "This Configuration".

Thanks, Derek

Too bad that the Solidworks help doesn't tell you that you can only modify a configuration by editing the dimension in the graphics area and not in the Sketched Bend properties (which is where you create it).

NH
NH 2017-05-17

Derek - Just before you change dim in little box you can change to this config here

This works the same way for having a configured plane, ie double click plane to get this box up so you change to this config and have plane with different distances.

comment imagecomment image