toolbox component replaced after reopening file

I was wondering if anyone else has come across this problem.

I use save as to make a copy of some TB components so i can add custom properties with out changing the original while also keeping that component in my project folder. this works fine however sometimes when i reopen a file (the assembly or drawing file) the component is replaced with the original stock toolbox component.  when i look in my project folder the copy is still there but i have to use replace component to re insert it. however this problem keeps happening regardless of how many times i replace component and save the file.  

SolidworksParts And Features
Answers 8
BH
BH 2017-04-20 Best Answer

Hi Jack,

Firstly, there are other ways to add custom properties to a TB part, you could edit the part and add a design table specifying the properties for each config for instance, or you could use the toolbox settings utility.

Are you renaming the file if you save it out as a new file? If not, there is a flag in the TB files telling SW it is a TB part, SW may recognise this and open the TB equivalent. You can remove this flag http://www.javelin-tech.com/blog/2011/02/toolbox-flag/. You'd still want to name the file differently though.

SC
SC 2017-04-20

What Version of SW?

If not using PDM make sure the part file is not read-only.

If using PDM? Make sure your settings for TB are so that you can update the configurator. This means that SW and PDM automatically check out the TB file that you are adding to the assembly (when editing) and check it back in after you are done.

I have found that PDM does not always check the TB file back in (hiccups). So it's important to double check the PDM pane in your assembly to see that it does. This is important when other users are using it as well.

JM
JM 2017-04-20

The files are being renamed (ex oring.ai-->as568-207 oring).

if i edit the part will that not edit the properties in other assemblies? 

Adding configuration properties might not work, i add supplier and part number to these components and we might get the same components from two different suppliers depending on the project.

JM
JM 2017-04-20

not using pdm. the part file is not read only.  My custom file is still in the project folder, solidworks just want to always grab the TB component instead of my custom file.

SC
SC 2017-04-20

ok

I think you just want to break the link to the toolbox in this case.

C:\Program Files\SOLIDWORKS Corp\SOLIDWORKS\Toolbox\data utilities

sldsetdocprop.exe

Open and run as shown below..

Select no.

comment imagecomment image
GS
GS 2017-04-20

See #5 at .  That will fix the problem.

JM
JM 2017-04-20

Thanks. I knew it was a setting I toggled by accident, just couldn't find it.

NR
NR 2021-09-23

I faced same problem, I fixed this by removing check in default location for toolbox component, as shown in screenshot attached below.

comment imagecomment image