I have two tables one is general and one is a revision. When I insert the revision table it automatically goes to the bottom left corner, but when I insert the general table I have to manually choose where it goes with the mouse.
How do I get it so that the general table automatically goes to the bottom left corner?
Thank You,
Craig
SolidworksDrawings And Detailing
I don't know of any way to make it go there automatically, but won't it snap to the corner when you drag it?
So is it just a thing that the revision table does?
Cause I was thinking it was just a option i had different for the two tables but I couldn't find it.
Table locations (Anchors) are set in the Sheet Format mode.
http://help.solidworks.com/2013/English/SolidWorks/sldworks/t_table_anchors.htm?id=9e6e7714aa6242bfb3e81fb19ed56b52#Pg0
Thank you. It gets the results that i wanted, but the thing with the revision table is that i would hit the check mark and it would be inserted in the bottom left corner but then i could still move it around. Using the Sheet Format Mode I cant move it after its inserted, but i don't need to so this work just fine.
Thank You Again
Craig