spiral extrusion or cut

How do i do this, have wasted about a week now trying to do this, always an error. SW is about the most non intuitive program i have used in the last 25 years even the website is difficult to navigate, its like going from PC to apple, I dont want apple !

Just want to sweep the face, dont even care if i have to clean it up after at this point...  'Inventor' just keeps caling ...  At this point i may as well use sketchup...

SolidworksParts And Features
Answers 5
PS
PS 2016-03-06 Best Answer

Reno,.. I did a loft and replace face for this...although, you may want to have it tangent but your construction guide does not show it tangent or normal to. (I added two more options as well)

comment imagecomment image
RS
RS 2016-03-07

Thanks for the reply do you mind explaining how you did it or upload the file so i can figure out how it was done ?

PS
PS 2016-03-08

Reno.. the attached file is/was there.. 

RS
RS 2016-03-09

Sorry again reading from my inbox...   Thank you for your help 

RS
RS 2016-03-09

4 examples you have gone above and beyond !    example C is what i was trying to do but i like example D it just makes more sense.  I have been deconstructing your examples to see where I was going wrong.  I just wanted you to know that,  so you don't think you were doing my work for me...  I'll recreate what i was trying to do using the other post you were helping me with and this one.          

Thank you so much !