speedpak in assemby drawing

I put a speedpak assembly in my assembly.  I started a drawing and tried to hide parts of the assembly that was speedpak.

I was not able to hide the parts I wanted to unless I switched the speedpak back to full.  This caused a bunch of mates error.

I am guessing that you should not use speedpak until after the assembly is done?

Is there a way to fix this?

Thanks, Joe

SolidworksDrawings And Detailing
Answers 5
JS
JS 2017-04-27 Best Answer

You can delete the speedpak configuration and add a new one when your done..

JP
JP 2017-04-27

You could create a new configuration linked to a display state that hides some components. Then create another speedpak from this config. In your drawing use the speedpak configs as needed.

JL
JL 2017-04-27

Thanks, for the response.

My background goes back to 1988 with cad programs.

I am concerned because the sp/pk surfaces did not relate over to the original model surfaces.

The issue is I work with modules and install other parts in them and the sp/pk is the module.

I am going to try the new configuration and see where that goes.

SC
SC 2017-04-27

Joe, why don't you just include the components need in the original speed-pak or maybe just the surfaces that are visible in the drawing view?

Steve C

DB
DB 2021-10-18

I'm answering in case someone else runs into a problem I encountered.  I tried opening a large assembly in Large Design Review but another designer had added a lot of speedpak configurations.  Solidworks gave me a message that the assembly can't be opened in Large Design Review if any speedpak configurations are active and that the assembly will open in resolved mode which is excrutiating waiting for.  I searched a while to find out how to find all of the speedpak configurations.  What worked was to use the feature manager tree search for the term speedpak.  This showed me sub-assemblies with speedpak configurations, which I could then switch off several at a time