spacing precision when making linear pattern

I am trying to use a .XXX place precision when drawing a linear pattern in a sketch but it seems it will only let you use .XX precision.  Even when I go to document properties and set the precision higher there it is the same.  This isnt the case when doing a linear pattern in Features, only seem to have this problem in sketch.  Any ideas?

GP

SolidworksParts And Features
Answers 10
JF
JF 2012-11-30 Best Answer

I am getting .xxxx precision.

is this where you set the document precision? this seems to control the precision on all of the PMs...

comment imagecomment imagecomment imagecomment image
GP
GP 2012-12-03

Well it must have been a Friday thing because it works this morning!   I had gone to the units setup and made that change but for some reason it just didnt work.   I had just installed my 13 update so I thought maybe I missed something, appreciate the response!

GP

LB
LB 2012-12-03

remember if you type in the numbe you want, 3, 4, or even 8 places it will stay that way!!!

the display is what you see, but when you double click the dimension you'll see the number you typed in for editing.

JF
JF 2012-12-03

that is not always true with the property manager or the "configure dimensiont" tables. it is true for dimensions entered in the normal ways

LB
LB 2012-12-03
<p>Jeremy Feist wrote:</p><p></p><p>that is not always true with the property manager or the "configure dimensiont" tables. it is true for dimensions entered in the normal ways</p>

Has worked for me since SW97 and which property manager for what feature that typing in the amount of places doesn't work because I haven't seen it happen and I instruct SW and worked for the VAR, though it has been 8 years since I've work for the VAR.

Now I have never used the configure dimension, I'll have to play with it, but it seems to be driven by the amout of places the options have set.

uptate....... i just played with it....not that good if you have multible place dimensions!!

This is not a good thing because maybe I don't want the software automaticly rounding and changing the number I typed in because of my design intent...not SW's intent! if it rounds it cause problems with the numbers need to build the part!

AW
AW 2015-07-27

so did anybody figure out what the problem is with that? when i use the linear pattern feature and try to dimension to the third decimal (1.125) solidworks automatically rounds it up to 1.13 and my pattern is out. how does one fix this. i have already set the document tolerances to the 4th decimal. didn't help..

SF
SF 2016-01-21

I'm getting this problem with 2015 linear sketch pattern. It allows me to enter the precision I want, gives an accurate preview with the precise dimension. Upon clicking ok, it rounds to two decimal places and adjusts the pattern to the two dimension size.

My units are set to five decimal places in the document.

Restarting computer had no effect.

Patterning one line was the same problem as patterning multiple lines.

SF
SF 2016-01-21

My work around for this problem was to use feature pattern. I made the extruded cut I wanted then patterned that feature. The spacing dimension and precision was the same as the sketch I wanted. The feature pattern kept the decimal places as entered, no rounding or truncating.

One possible solution is playing with the four rounding schemes in document properties>units. It seems like this could be connected in some way, but I didn't make any trials.

GP
GP 2016-01-21

Wow,,, this is a flash-back post! 

   We are now on SW16 and for fun I just went and tried the sketch pattern.  No problems as I had that day back in 2012! 

AI
AI 2023-11-13

I fixed this issue by increasing the decimal precision within the units settings tabs.