Dear all,

I was wondering if someone could advise me regarding an issue with solidworks flow simulation. I am running a transient simulation which take days to finish for each simulation. Previously I can stop the simulation at any time during the simulation and save the current data. Then the simulation can be continue later.

However, I found that recently for different model, whenever i stop the simulation and try to continue it later, this message will appear

' Solver abnormally terminated. Please contact the support service'. And I have to start the simulation all over again. I have check that I have no issue with RAM and hard disk space. Also the model is correct.

Therefore, I am really appreciate if someone can advise me regarding this issue.

Thank you.

Syarif