solidworks with sigmanest

I drew up two Plexi doors in solidworks.  one door I drew up in 2007 and converted it into 2009. the other I drew up in 2009.  The door that was drawn up in 2009 will work in my sigmanest 8.1 the other door does not.  there is only one other difference between the two doors. the one in 2007 i canged the plane of the first sketch from front to top.  Both doors have two dados on the left and right side.  My question is what would  be the reason one will work and the other will not?

Hope someone can help.

Sigmanest support is out of answers

Jeremy

SolidworksGeneral
Answers 3
TS
TS 2009-08-13 Best Answer
Is there a specific error that SigmaNest is giving you? Also, what build of SigmaNest are you using? The way they control the release of their software is ridiculous. Don't fret, SigmaNest support has never been able to address our problems either.
SF
SF 2009-08-13
i keep getting a error that says that there are open contours.  i am using version 8.10
TS
TS 2009-08-13

Ok, open countours means just that. There is open geometry in your profile that SigmaNest does not like. This happens often to us. Would you be able to post you parts so i can take a look at them? It may have something to do with the dado cut features you added.

If you can't and this error won't go away, you can always export your cut profile as a .dxf and then import it into SigmaNest.