"Snap hook could not be created from a given geometry"

I'm at a loss, everything looks good: I've utilized the split command to create a clamshell frame. I utilized move/copy to rotate it open. I created a hinge and folded it closed using the flex command. It will not let me create a snap hook. Where could I be going wrong?

SolidworksParts And Features
Answers 4
JM
JM 2016-02-26 Best Answer

Can you attach your *.sldprt file here?

SF
SF 2016-02-26

Sure, here it is.

SS
SS 2020-06-14

"Snap hook could not be created from a given geometry"?

GH
GH 2022-09-23

Been climbing the Snap Hook learning curve in SW 2020 and I saw that message incessantly until I discovered that the Snap Hook feature seems to work when located on an interior face. I'd been attempting to attach the hook to an exterior edge/face with the hook pointing inward which consistently produced the above error message. Seems to be a little constraining...but perhaps I'm just missing some subtlety.