Sketch won't wrap inside cylinder

Hello,
I'm trying to wrap a sketch around the inner part of a cylinder followed by a swept cut, using the wrap as a path. Problem is I can't the sketch to wrap around the inner cylinder. Tips/evaluations on the rest of the part is accepted.   Thank you.

SolidworksParts And Features
Answers 4
DB
DB 2016-01-26 Best Answer

Edward,,, I moved your sketch back slightly (.003") towards the center of the model slightly and it wraps as expected. Apparently part of the sketch was outside (or on the edge) of the cylinder.

comment imagecomment image
EH
EH 2016-01-26

Thank you for the response Dennis. So during a wrap I can't have the sketch outside the bounds of the body? And how did you move the sketch? Thank you.

DB
DB 2016-01-26

Apparently the wrap failed because the sketch end points were right on the curve of the "Cut-Extrude13"... I moved the sketch by deleting the coincident relations at the end points and then added a dim to the horizontal line. I found that if I made that dim .001 it worked also. I played with this a little more and rolled up above the Wrap and added additional material outside surface of the main cylinder then rolled down and the wrap worked without moving the sketch. Then sliced off the additional material. I have attached a file. It looks to me you have done everything correctly and efficiently (for tips and evaluation). I'm sure someone will disagree with me on that though.

EH
EH 2016-01-26

Thank you Dennis, I see what you did now.  I would of never thought of doing that and thank you for the compliment, I want to get better.