I am getting the following warning message attached to a SHELL feature...
To allow the shell to complete, the level of checking between pairs of faces has been reduced. Downstream operations that use this shell's geometry may have problems.
The model looks good, and the shell feature seems to be working, but there is still the warning message.
The model is still in SW 2010 (customer requirement). I have opened the model in SW 2011 (a copy), and I get the same warning message.
Any help would be appreciated.
Thanks,
Todd
Misc: Info
Feature Statistics:
M6015315-001_3(2011) 10/11/2011 8:09:51 AM
Features 480, Solids 1, Surfaces 10
Total rebuild time in seconds: 86.22
In the model attached I have deleted all the features that were after the Shell command, and as you can see the warning message is still there.
SolidworksGeneral