Sheet Metal Weight Calculation

Does any one know whether it is possible to have Solid Works calculate the weight of a part without all of its cutouts? We want the calculated weight to be closer to the actual material that is used, and scrapped rather than the actual weight of the part. Example: we cut a 36" X 72" piece of sheet metal for the part, but the part has a 24"x 48" cutout in the middle. we need the weight of the 36"x 72" piece as a whole because the 24"X 48" piece is scrap and should also be figured into the cost of the part.

SolidworksSheet Metal
Answers 4
SP
SP 2012-10-30 Best Answer

Suppress the cutout in the feature manager tree and that will get you the weight you are looking for.

SF
SF 2012-10-30

Greg,

It seems like I remember something about there being a way to get access to the bounding box dimensions, which would get you the numbers to calculate the weight you want. You might need a macro to get the data and calculate the weight. A macro could also allow for any extra size needed for the blank.

Not being a macro person, I would be inclined to just make a configuration of the part without the holes. I think you can set up a configuration specific property for the weight, but I am not sure about that.

Jerry S.

SF
SF 2012-10-30

ok, that is helpful, but I cannot have the feature suppressed when I print the drawing. This is a good Idea though and I will see if I can figure something out so that this will work for us.

PM
PM 2012-10-30

I agree with Jerry on making a configuration of the part without the holes.