Could you please help me understand why there is a flat surface on only one side in this flat pattern, even though both sides are symmetrical?
Could you please help me understand why there is a flat surface on only one side in this flat pattern, even though both sides are symmetrical?
Upload your model.
It is because at the top side bend, the right portion is going downward: the bend angle is not equally shared at the flanges).
In your bent image, you can see the bend radii at this junction are not equal. The right bend radius is not running normal to its top side face, but at an angle that's elongating the bend. The that flange starts and is at its own angle.
On the left side of this junction, the bend radius is normal to its top side so there's continual flow to that flange.
As John requested, please drop your part file into a reply for a direct examination as I can't replicate this with my workflow of one edge flange op for all four flanges. SW trims things up nicely.
Try setting Simplify Bends in the Flat-Pattern properties.