Rolling Sheet Metal into a circle

Hi,

I'm not familiar with sheet metal function in solidworks and I was wondering how you would roll a piece of flat sheet metal to a full circle. From what I can see you cant complete a full circle so 359° would do.

I am creating a vessel shell from several flat welded plates and need to show in what position to weld them when in the flat state. But it would be also good to show it in the rolled state.

Hopefully the attached will help, those are my six sheets which need rolling into a circle (around Ø3820 (3*4000mm sheets)).

Jonno

SolidworksSheet Metal
Answers 9
DG
DG 2012-05-31 Best Answer

Revolve a line at 359° and then you can convert that into sheet metal

OR

Create an arc with 359³ and simply use the base flange option in sheet metal.

These videos should be helpful

http://www.youtube.com/watch?v=CqjVE6R1W3k

http://www.youtube.com/watch?v=BJr0dHth_cM

SF
SF 2012-05-31

Thank you for your response,

But I need to show several plates together making the one rolled sheet. The last sheets either side being staggered.

The method those videos are showing have a gap from top to bottom of the rolled shell, my sheets need to be staggered.

See attached, when its unrolled I want it to be like this. when its not flattened it returns to normal???

I would like to also be able to see all the sheets when its not flatterned (rolled)

Jonno

SF
SF 2012-05-31

Not quite sure what exactly you are after but maybe if you make

each part a separate part, then create an assembly of all 6 parts.

this may also help.

flatten (UNFOLD), then cut (EXTRUDE CUT), then fold (FOLD).

comment imagecomment image
SF
SF 2012-05-31

Jonathan, I think I now know what you are after.

Try this on for size and let me know what you think.

If you want a flattened view with all parts laid out together, you can create that assembly also.

SF
SF 2012-05-31

Hi Chad,

Thank you for your response.

It seems to be the way i would like to go from your picture but unfortunatley i only have 2011 SP0 so im unable to open you files, anychance you have previous version???

Jonno

SF
SF 2012-05-31

Cannot help you with SW 2011 files so I created an instruction document file. I saved it as a .doc file because you probably do not have the upgraded office (.docx) either. I hope this helps you out a bit.

I was borred here at work, all caught up with nothing to else to do.

KB
KB 2012-06-01

probablly not exactly what you describe but it should provide an alternate approach.

i assumed 48" x 96" plates/sheets

no way to flatten all at once.

see attached 2011 file

SF
SF 2012-06-07

You could use configurations to make your vessel. In your part add a configuration for the flattened state. Build an assembly and add a configuration for the flattened assembly. Then just toggle between the two.

This example may not be the exact shape plates you need, but the technique should work for you.

(FYI, these are 2009 sp3 files.)

comment imagecomment imagecomment imagecomment image
SF
SF 2012-06-12

Hi Harold,

Thought there might be an easier way then this, but who cares this method works fine for what I am needing.

Thank you very much!!