Real View keeps turning Grey

Good Morning everyone,

i seem to have an issue with my real view keeps turning my assembly to this grey looking thing, i have been looking through the forums and a few people said it was because of large assembly mode (not the case for me)

i have a K5000 graphics card, 32 gig of ram, i7-4930k cpu, all with the latest drivers (computer is only 3 weeks old).

anyone have any sugestions?

Thanks

Damien

SolidworksGeneral
Answers 5
KL
KL 2014-03-24 Best Answer
...all with the latest drivers

Latest from the manufacturer or latest approved from the SolidWorks site?

Run the SW Rx diagnostics tool to check, and for the approved page link.

DB
DB 2014-03-25

yes i have the driver that has been tested by solidworks.

DB
DB 2014-03-31

bump, anyone have an suggestion? i have run the Solidworks RX and everything has green ticks

JH
JH 2014-03-31

Do you have a particular scene applied that could be changing shading, etc?

DB
DB 2014-03-31

No nothing special just the standard scene, that it starts out at. i have tried a few things like using the pak & go to bring all my files into the one location as i was pulling a fair amount off our server but that didnt do anything, only happen when i modify somthing so i needs to do an update, like if i modify a part in contect or make a change externally and come back into the main assembly.