Please can anyone suggest a method to create this kind of profile of crosses on top of a nail in Solidworks?
cut- extrude
@VD If its the bumps on the top of the nail, please check this video https://www.youtube.com/watch?v=jHfFWFArX3U
Similar to this?
If you don't need it as actual 3D geometry then just using a Knurled surface finish on the face would do the job.
This could be another way of creating the pattern, but it may affect rebuild time.
Their versions are not quite correct. This one is saved to SW2023.
cut- extrude
@VD If its the bumps on the top of the nail, please check this video https://www.youtube.com/watch?v=jHfFWFArX3U
Similar to this?
If you don't need it as actual 3D geometry then just using a Knurled surface finish on the face would do the job.
This could be another way of creating the pattern, but it may affect rebuild time.
Their versions are not quite correct. This one is saved to SW2023.