Parts only visible when selected or when moving view

Hi, straightforward but extremely frustrating issue here; without having to my knowledge changed any display settings or anything in Solidworks, when I have parts or assemblies open I can work completely normally, add features change things etc, except that parts aren't visible unless I have them selected or am in the process of moving the view around (i.e. have the scroll wheel held down). I suspect there's some setting somewhere that was somehow changed that I don't know about, but I can't for the life of me or with my Google-fu figure out where it is any help appreciated.

This is definitely an issue with my program and not the part, as it happens with any part/assembly I try to open, and they open and display normally on other computers.

Thanks

Brian

SolidworksParts And Features
Answers 10
RV
RV 2013-03-28 Best Answer

Dear Brian,

Go to Options>System Options>Performance>Check the option use Software Open GL.

comment imagecomment image
SF
SF 2013-03-28

Actually after opening and closing a few more documents the issue resolved itself, weirdly enough.

Incidentally that option is greyed out for me, though clearly it wasn't the problem.

JH
JH 2013-03-28

I know it a much-used excuse, but it sounds like a graphics card issue. Are you using a SW-approved card and the correct driver?

SF
SF 2013-03-29

Brian,

That option is greyed out for everybody, unless you close out all of your parts, assemblies and drawings, or try it before you open anything.

Jerry S.

SF
SF 2013-04-22

Yes I am, NVIDIA Quadro 600. I only come back to respond because I've noticed a significant drop in performance since enabling OpenGL and am wondering if it might not have been the best solution (from reading elsewhere it looks like it is a replacement for your normal graphics card driver? I don't understand much of the technical hardware/firmware stuff). Any ideas what could be causing this issue (which persists if I disable OpenGL)?

SF
SF 2013-04-22

So this solution worked, but I also have begun experiencing significant performance hits since doing it (possibly not exactly correlated but I believe it is). Is enabling OpenGL circumventing my usual graphics card drivers (this is a basic impression I've gotten from tangential unrelated reading)? If so is it possible that this could be why now that I have it enabled SW appears to be running significantly more sluggish than before? My graphics card is NVIDIA Quadro 600. Thanks for any more help you can give me.

Edit: Also I can see the part/assembly if I have a face selected.

AV
AV 2013-04-22
SF
SF 2013-04-22

Yes I do.

SF
SF 2013-04-22

This worked to solve the parts-not-appearing issue, but greatly reduces my performance while running SW. I believe that with the NVIDIA Quadro 600 graphics card I'm using, I shouldn't have to enable Software OpenGL. But without it this problem of parts only being visible when selected or moving the camera persists.

SF
SF 2013-04-22

Brian,

Yes, running with Software OpenGL slows your system down and no, you should not have to run that way. Check http://www.solidworks.com/sw/support/videocardtesting.html

to make sure that you are running an approved graphics card driver for your computer, card, operating system and version of SolidWorks.

If that doesn't fix your problem, then it may be that your graphics card is failing.

Jerry S.