Need Help making a straight flange off of rolled piece

I am trying to take a flat dxf, roll it, but leave a section of it flat. I have been unsuccessful so far in creating a usable sheet metal file. I was able to fake it but I would like to do it the right way. Any help would be great. I have attached the file. I am using Solidworks 11 sp3

SolidworksSheet Metal
Answers 7
PM
PM 2011-08-30 Best Answer

Pic attached

comment imagecomment image
DG
DG 2011-08-30

Can't open up your part but did you tried using sketched bend?

PM
PM 2011-08-30

Deepak, Yes I tried using a sketch bend. I attached the flat pic. When I use the sketched bend it bends the whole part and I haven't been able to figure out how to keep part of it flat.

comment imagecomment image
DG
DG 2011-08-30

Create the bend portion first and then add the straight portion as tab. But make sure you add the relief as this might cause problem for create the flat pattern.

TP
TP 2011-08-30

See attachment, is this what you are trying to do?

PM
PM 2011-08-30

Thanks for the model Troy, that is what I was looking for. I never thought about drawing it that way.

Deepak, I tried your method but it would put the tab added as a multibody. Unless I am doing something wrong.

Thanks for both of your help.

DG
DG 2011-08-30

I doubt why it put the tab as multibody.

  1. Draw the bend profile and extrude using base flange in sheet metal.
  2. Start a new sketch on the flat portion of base profile for the tab (including the cut/bend relief)
  3. Hit TAB and it should be good to use as one body.