I have an assembly constrained to a 3-d spline with acoincident restraint.
There is a perpendicular plane restraint to keep it from swaying.
The problem is when I pull the assembly around the spline,occasionnally the
assembly will flip 180 degees. If I try to add another constraint,it warns me that the assembly is overconstrained. Anysuggestions?SolidworksMotion Studies

There is a perpendicular plane restraint to keep it from swaying.
The problem is when I pull the assembly around the spline,occasionnally the
assembly will flip 180 degees. If I try to add another constraint,it warns me that the assembly is overconstrained. Anysuggestions?SolidworksMotion Studies

I would try to stay away from both parallel and perpendicularmates. Could you offset the path so you have two paths to followand mate your part to both paths, locking the part's orientation?I've never tried it. Is your assembly too large or confidential toupload and zip it and it's parts for us to look at?
Took a look at your file and I have a suggestion. In your ConvCLpart, take the 3DSketch-ConvCL and use it for a surface extrudeselecting the top plane as your reference direction. I beleive thiswill give you a surface thru your path for your motion. You canthen get rid of the perpendicular mates, and add mates between thissurface and the endpoint of the sketch entity that you revolvedyour kingpins around. I think this will mate the axis of thekingpins to the surface of the path (keeping the part in thecorrect orientation). I tried it with the Intermediatte3 part, andit seemed to work for that part, I didn't do it for the rest of thefollowers. I'm on 2009, you're on a previous version, or I wouldupload what I did.
Hope that helped.
I tried your suggestion. It seems that the point-mate-sukrfacetreats the surface as infinite in height. It still flips.
Extrude the surface the distance down to the end of the pins. Thenyou can mate the endpoint of the line used as the center of the pinrevolve to the edge of the surface. Now the pin has two pointsmated to two paths. I don't see how it could flip then.
If this works you could just use the surface's two edges to matepoints from the pin to.
The axis of the pin does not stay normal to the vertical curve doto the fact that there are two pins involved and it needs to pivotat the top.