Model to big for 3D printer. How to split?

Hello, I have a model that looks like a drawer. I tried to print it using a 3D printer but the printer's build area is too small. For example, the length of the model is 8cm longer than the size of the build plate. What suggestion do you have? I think I saw a feature that could split the object into jigsaw-like parts so that the two parts could be printed separately and then combine later. 

SolidworksGeneral
Answers 10
SL
SL 2015-05-25 Best Answer

Use Surface Cut,

comment imagecomment image
PC
PC 2015-06-13

Thanks. This method seems to be able to cut based on the plane. How to do patterns like:

Which of these is recommended to connecting the two parts? Any other suggested patterns appreciated. Thanks.

comment imagecomment image
DG
DG 2015-06-13

I would prefer method/option 1

SL
SL 2015-06-15

Hi Peter:

I prefer option 2 , and you need to use some adhesive to fix both together.

For option 1, there are two problems:

  1. Difficult to achieve the tolerance required to join both parts together.
  2. Create weak edge / stress concentration.

Regards

DG
DG 2015-06-15
<p>Shaodun Lin wrote:</p><p></p><p>For option 1, there are two problems:</p><ol><li>Difficult to achieve the tolerance required to join both parts together.</li><li>Create weak edge / stress concentration.</li></ol>

The tolerance could be easily achieved and sharp edges can be waived off by adding fillets, hence no stress concentration or weaker edges.

PS
PS 2015-06-15

Yes, with a cut offset for the additional material created from each side in RP build..

comment imagecomment image
PC
PC 2015-06-16

What is "RP build"?

PC
PC 2015-06-16

How to determine the amount of offset? Is there a recommended value? Thanks.

PS
PS 2015-06-16

Peter,

RP - Rapid Prototype (material/process,.. SLA, SLS, FDM,..)

Offset distance would be the additional material per the material/process (or per side(s)),... and hi-res compared to standard,.. X, Y and Z build directions to determine additional material per side(s).

Easiest answer is the send them the part and let them know what you want to do and have them agree with to splits for them to rejoin..that is, have them do it for you?

CH
CH 2015-06-22

You need to leave enough clearance that the two halves are printed "line on line"; and for the adhesive as well. If you're using ABS I would mix up some ABS slurry in the same color filament. I've had good success with that; otherwise plain old superglue will work.