Hi everyone,
I've noticed a problem as of recently that is driving me mad... Ihave some labels drawn up in 3d and I put them into 2d drawings forour control documentation here. When I put the front and side viewson the page, everything looks okay, but when I add an isometricview, it looks very dark. The first time this happened a few monthsago, I just went back into the part and added a spotlight to thefront. The problem went away immediately on the drawing. Now, forsome reason after a small modification to the drawing (I added somenotes), the isometric view is dark again. But here's the kicker...when I drag the view to the bottom or to the left of the page, itgets progressively brighter. The farther up and right I drag theview, the darker it gets. To my knowledge there are no brightnesssettings while in drawing mode... any ideas?
Thanks,
-DaveSolidworksDrawings And Detailing
I've noticed a problem as of recently that is driving me mad... Ihave some labels drawn up in 3d and I put them into 2d drawings forour control documentation here. When I put the front and side viewson the page, everything looks okay, but when I add an isometricview, it looks very dark. The first time this happened a few monthsago, I just went back into the part and added a spotlight to thefront. The problem went away immediately on the drawing. Now, forsome reason after a small modification to the drawing (I added somenotes), the isometric view is dark again. But here's the kicker...when I drag the view to the bottom or to the left of the page, itgets progressively brighter. The farther up and right I drag theview, the darker it gets. To my knowledge there are no brightnesssettings while in drawing mode... any ideas?
Thanks,
-DaveSolidworksDrawings And Detailing
