Library parts not being recognized as library parts in vault check in

Hello All---

I just defined all of the design libraries in pdm workgroup's admin interface. The vault and design library are on the same CAD server. I ran a test and tried to check in some of the individual parts that I was going to be using in a larger assembly as a test to see if the references were working.  When doing so I got the error that said, " Cannot check in because admin does not allow check in of library components." Then I used those same parts in a larger assembly.  I went to save and check in the larger assembly and the vault only recognized 2 out of the five or so design library parts.  Has this happened to anyone before?

Thanks.

Sincerely,

Chris

SolidworksWorkgroup Pdm
Answers 2
SF
SF 2012-10-24 Best Answer

Hello All--

This was actually caused by a copy of the library part being in the same local directory as the assembly I was trying to check in.  The vault will not recognize the library part if a copy of the part exists in the local directory.

Sincerely,

Chris

KB
KB 2012-10-25

yes, that is correct.

library components must be pulled (referenced) from library folder.