IsFastener

I know I've asked this before, but I haven't received an answer that satisfies me yet. I am not able to verify the existence or functionality of the IsFastener custom property for PDMWorks or section views. I know this is supposed to work, but I also know that I can't find it or create it such that it actually does work. I don't see IsFastener in the list of custom properties, and parts with the property are still sectioned by the section view tool and by section views on drawings.

Is this a local problem or is the functionality different in 2009 and later?

SolidworksToolbox
Answers 5
ML
ML 2009-08-08 Best Answer
Ok, I can get it to work with IsToolboxPart, but Toolbox parts do not seem to have this property by default. Any definitive clue what's going on?
SF
SF 2009-08-08
"IsToolbox" is turned on as a default for all toolbox parts. It is just hidden from the users. There is a utility "sldsetdocprop.exe" in the "C:\Program Files\SolidWorks\SolidWorks\Toolbox\data utilities\" folder that you can run to remove the "IsToolbox" flag.
SF
SF 2009-08-09

IsFastener in section views works for me. I've switched the option to exclude fasteners on and off to see the effect and I've also deleted the the property from my file. In each case the section view updates correctly.

This was used on a simple rivet that I drew up and added the IsFastener property.

No idea about PDM as I do not use it enough.

SL
SL 2009-08-13

Matt,

I’ve included an image below that shows where each of those parameters (IsFastener and IsToolbox) is used in the system.

As you know, the IsToolbox “flag” is an internal setting that is set by default on all Toolbox components. It can also be set (or removed) on any component using the “sldsetdocprop.exe” program located in the \Toolbox\data utilities\ folder of the SolidWorks install directory.

IsFastener is a special custom property that you can add to any part file to enable the special behavior in drawing section views and interference detection. If “IsFastener” is not in your custom property dropdown list, you can manually type it as the custom property name and/or add it permanently to your list of custom properties. The key to getting this to work (apart from spelling the name of the property correctly) is to set the value of the property to 1.

As you can tell from the table below, both Workgroup PDM as well as Enterprise PDM only acknowledge the IsToolbox setting. Finally, I should point out that neither of these parameters is taken into account when you perform a section view (View – Display – Section View) in the part/assembly environment.

I hope this helps.

comment imagecomment image
ML
ML 2009-08-23

Perfect. Thanks for setting that straight.

Matt