I have not worked with GD&T much, can someone give me input concerning this drawing
Refer attached.
James,
Here are some references that might help you in understanding GD & T
http://synthetica.eng.uci.edu/~mccarthy/mechanicaldesign101/GDandT.pdf
http://www.ise.ncsu.edu/wysk/courses/ISE316/Chapter%20%203-8-31-10-%20Geometric%20Tolerancing.pdf
https://forum.solidworks.com/thread/42571
You might also want to look into purchasing ASME Y14.5-2009
Check out the local community college that has a design/drafting, industrial tech or manufacturing tech curriculum. They may have classes in GDT.
Very good to know.....
Cheers,
Anna
This may help some.
this is a good reference for me.
I'm glad, you are welcome.
Thanks Tony!!!
That is exactly what I used to have at my old job. Could never find it again after I was left go.
That and a few other charts/stuff are on my UG https://forum.solidworks.com/groups/palmetto-solidworks-user-group
Refer attached.
James,
Here are some references that might help you in understanding GD & T
http://synthetica.eng.uci.edu/~mccarthy/mechanicaldesign101/GDandT.pdf
http://www.ise.ncsu.edu/wysk/courses/ISE316/Chapter%20%203-8-31-10-%20Geometric%20Tolerancing.pdf
https://forum.solidworks.com/thread/42571
You might also want to look into purchasing ASME Y14.5-2009
Check out the local community college that has a design/drafting, industrial tech or manufacturing tech curriculum. They may have classes in GDT.
Very good to know.....
Cheers,
Anna
This may help some.
this is a good reference for me.
I'm glad, you are welcome.
Thanks Tony!!!
That is exactly what I used to have at my old job. Could never find it again after I was left go.
That and a few other charts/stuff are on my UG https://forum.solidworks.com/groups/palmetto-solidworks-user-group