I have a common part which sees two different sets of boundary conditions. I want to run these sets of boundary conditions in two different studies and then add the result together in the pressure vessel module. So far so good but the issue is whenever I try to mesh the parts with same mesh settings in the two seperate studies I end up getting different number of nodes. All mesh settings including mesh controls are identical on definition and location. I cannot add the two studies together since they have different number of nodes. The difference is only couple of nodes but that is preventing me from adding them. Is this normal in solidworks or am I doing something wrong here.
Thanks for the help
Jaspreet Hothi
SolidworksSimulation