force state change of drawing when changing state of part

Hello, 

We are looking to implement a process in the PDM we cannot figure out how to realize. Our drawings and parts have different revisions, so that we can change a drawing without changing the part (drawing depends on the part but part does not depend on the drawing). But, we don't currently force in the PDM that a drawing be transitioned from Released to Draft when the part is transition.

So, the question: is there a way to force the transition of the drawing when transitioning the part but not the drawing when only transitioning the drawing?

Thanks

SolidworksSolidworks Pdm/enterprise Pdm
Answers 4
JS
JS 2021-04-08 Best Answer

1-1AYIYE7 wrote:

Hello, 

 

We are looking to implement a process in the PDM we cannot figure out how to realize. Our drawings and parts have different revisions, so that we can change a drawing without changing the part (drawing depends on the part but part does not depend on the drawing).

What benefit is there to not keeping the model and drawing revisions the same? 

 

So, the question: is there a way to force the transition of the drawing when transitioning the part but not the drawing when only transitioning the drawing?

 

You can do this by writing an add-in.  But it is much simpler to simply implement procedures that dictate the model and drawing revisions should always match.

DM
DM 2021-04-08

Same here.

We have an 'uncontrolled edit' state change that is only visible to senior engineering.

Ideally it would be better to up issue no matter how small the change(even clerical as at the end of the day a drawing change is a drawing change) but in reality and depending on company processes it may not be feasible.

For simplicity I would look at changing your processes so drawings and parts always carry the same revision.

JS
JS 2021-04-08

Philipp Waibel wrote:

Hi Jim,

 

If we need to make a small change (such as updating an aspect of the drawing that is not included in the part), we can do so without changing the revision of the part. This is particularly use for for a DCO, where you want to correct an omission on a drawing that doesn't impact the part. Then you don't have to re-release all parent assemblies, just the drawing. We 

We have a 'Non-Revision Change' transition for that sort of thing.  The drawing revision doesn't get changed, so it and the model revision stay synchronized.  It requires some extra care though if parts are out being made.to ensure that updated drawings get to the right people.  Of course if the change is anything other than clerical, a revision is the better choice.

SF
SF 2021-04-08

Hi Jim,

If we need to make a small change (such as updating an aspect of the drawing that is not included in the part), we can do so without changing the revision of the part. This is particularly use for for a DCO, where you want to correct an omission on a drawing that doesn't impact the part. Then you don't have to re-release all parent assemblies, just the drawing. We