I have an assembled door, 80-20 type, frame & panelconstruction, where the hinges are attached to the doorsub-assembly. When installed at then next level as a flexibleassembly, the upper assembly reports mating errors within the doorassembly which causes issuse with other the upper assemblymates(over defined). But when I switch over to the door assemblyfile everything is fine with the mates. The door will open/closebut is sluggish and will rebuild with various different matingerrors- or sometimes no matting errors at all.
Is there some way to assemble these doors to avoid sub assemblymating issues in the uper level assemblies?
One work around I'm trying, is to create a door configuration withthe hinges supressed and adding the flexible hinges to the upperassembly (but with them excluded from the B.O.M.) There I installthe door rigid but mated to the flexible hinges. I avoid thesubassembly mating over defined issues but I still have a hard timemoving the doors especially as they approach the range of motionlimits -they don't always want to fully close.SolidworksAssemblies
Is there some way to assemble these doors to avoid sub assemblymating issues in the uper level assemblies?
One work around I'm trying, is to create a door configuration withthe hinges supressed and adding the flexible hinges to the upperassembly (but with them excluded from the B.O.M.) There I installthe door rigid but mated to the flexible hinges. I avoid thesubassembly mating over defined issues but I still have a hard timemoving the doors especially as they approach the range of motionlimits -they don't always want to fully close.SolidworksAssemblies