Flange Direction Configuration

I have a piece with a single bend and two alignment holes that is affixed to a door on the top and the bottom.  They would be identical except for the direction of the flange.  It's easy enough to make two pieces but I'd rather just have 2 configurations.  Is this possible?

SolidworksSheet Metal
Answers 5
SF
SF 2014-01-24 Best Answer

Look into Insert, Mirror Part. Great function, I use it a lot for those kind of parts.

SF
SF 2014-01-30

That does the trick.  Thanks.

It still makes a separate part though.  It would be nice if bend direction was a configurable feature

SF
SF 2014-01-31

Tim,

I'm not sure if it works with Sheet Metal parts, but I think that you can Mirror your body inside your part. In your first configuration, suppress the Mirror. In the second configuration, delete the original body.

Jerry S.

SF
SF 2014-02-02

Tim, You're welcome. If Jerry's suggestion works for you please post your results. You can switch the correct answer to his pretty easily too.

TS
TS 2018-11-13

Hey peeps, I've recently been playing around with this and found if you can control the direction with a sketch them the dimension is configurable up to 360°, with a bend its only up to 180°, it would be nice if they simply made a bend feature be able to go up to 360° then you could configure the ° dimension to control the direction.