fault finding- camworks or solidworks

Dear Solid works people,

this issue is part of camworks but being a newbie I beleive it is an issue in solidworks, user induced!

Brief,

opened a part in Solidworks 2013 get  an error (see image)

when I create a tool path simulation it looks like this. (attached) Where do I start to fault find....?

SolidworksGeneral
Answers 2
CM
CM 2013-08-09 Best Answer

What units is your Solidworks model set to?  I could only see Camworks having problems with feet & inches (still very unlikely) but any other set of units should be recognized.

SF
SF 2013-08-09

The model (part) is in mm (metric) the post processor is also metric along with the tool crib.....

I did create the model on another comouter running solidworks, then transferred it to a computer running SW and CW to get g-code....

where would i start looking?, when i  (smart) dimension the part - it looks ok, however the dimension show annotate differently

little lost