I keep getting the error message Parts cannot be moved into a position that satisfies the mate. Faces are not parallel. Angle is 0.00 deg... Im only getting these messages in one assembly and its doing this for distance mates and concentric mates. how can something be not parallel with an angle difference of 0.00 deg??
SolidworksAssemblies
change angle precision to 0.00000000 or 8 places
you should see an angle
It could be 0.003 deg or whatever but only showing you 0.00 because of the settings you are using.
Check the angularity in sketches of the parts, if lines are vertical, horizontal etc.
You can edit sketches in those parts that are behaving that way and my guess is that some of the lines are blue i.e. not fully defined, you could have accidentally left one in an angle. If you use the fully define sketch button to add relations to the rest you will probably find the angled lines.
well there lies another problem. Im working with import files from Ford so i dont have any sketches. This wasnt happening until i added a configuration to stretch the chassis. i mated all of the parts to where they needed to me the sliced the chassis rail and moved it. for the first hour or so everything was fine and now it wont correct.
You can add distance mate to the front,right,top planes in the part that has problems, instead of the faces or planes and edges or whatever.
thats probably going to be the only thing i can do at this point. I raised my precision and still have an angle of 0.00000000 deg. so im not sure what else would even be possible at this point
That's what I have found too, if the measure tool does not say "Parallel" or "Perpendicular", it isn't.