Extruded parts

I have parts used in our assemblies with a unit of measure in our ordering system of FEET. How do I go about drawing the profile of the part then using it in an assembly in a way that the BOM will show the quantity in feet used. The raw material for the part is straight, but the part may be bent or rolled during assembly.

PS: we are using SW2011 and EPDM2011

SolidworksDrawings And Detailing
Answers 5
AW
AW 2011-12-21 Best Answer

Create a Custom Property, then change your BOM Qty to that Property.

Not sure how that will work with EPDM......

Cheers,

Anna

comment imagecomment image
SF
SF 2011-12-21

That is one option we thought of. But there must be an easer way. If we useded a sweep, could SolidWorks report the length? In AutoCad we would use a polyline to determine the length of a path.

JF
JF 2011-12-21

I believe if you set this up as a weldment profile, the cutlist will get you the length used. I have never used welments in EPDM though.

SM
SM 2011-12-21

Ron,

Worst comes to worst you can add a custom property that shows the units

then incoporate that into your BOM.

SF
SF 2012-05-07

I ended up using a custom property "Unit Length". Setting it equal to "BOM QTY" works for the drawing but not EPDM, it also tends to get wiped out when new configurations are added.

To get it into the EPDM bill, I add 2 attributes to the "Length" variable. $PRPSHEET for slddrw and CustomProperty for slddrw, sldasm, sldprt. Then add the length column to the Bill of Material format. My import route handles multipling Quantity and "Unit Length", defaulting to 1 if "Unit Length" is missing.

In the parts I added $PRP@Unit Length to the design table, and calulate the length from the other paramiters.