Hello everone,
I have this part, where I needed a few equations to know how much tube I need to cut everytime I insert a diferent dimension.
This part has 3 different dispositions that are dependent on the width:
One option if width is smaller or equal to 1180mm
One option if width is bigger than 1180mm but smaller than 1601mm
One option if width is bigger than 1600.
I know that there's a little error on the 1600 and 1601 bit but it's ok for what I need to achieve.
My problem now, is that I need drawings of the 3 different part options but I have no way to change the widht value and make it change just one drawing at a time beacuse I have no configurations.
If I had a configuration to a specific width SW will no longer let me change widht anymore.
I don't know if I'm making myself clear..
I'll leave the part attached.
Thank you in advance
SolidworksDrawings And Detailing