CSWP Section 1 Exam

Dear All,

I have just had another go at the CSWP section 1 exam and failed again . Not too sure that Swx 2012 SP1 didnt help, but it could have just been me.

Can anyone tell me if it is advantages to update the model with the new dimensions when doing the changes to the model before you carry out the modification or after? Its something that came to mind in the exam and put me off a little, as i never thought about it.

I also tried to re-order a part which 2012 wouldnt allow me to do, so i waisted time sorting that out, had to frig it in the end, which was pointless really. When i went back into the drawing after the exam it re-orded perfectly well. So i thought it was something to do with when i updated the changes to the model?

Anyone else failed and what issues did you run into?

Also just seen some good comments on doing the cswp, wish i had found them out earlier!

Back to the drawing board, so to speak

Steve

SolidworksGeneral