Create parts from the toolbox configuration screen

I want to create some fasteners from the toolbox for a project that I am working on and have run into a issue with creating them.  I exported the data from the toolbox and altered it with Excel and then imported it back in per the instructions.  The issue is that anything over a #10 or 0.190 fastener (SHCS, SSS, FHCS, BHCS) the part number will be 10-32 x 1.875.  I tried only creating only above the #10 size and then all the part numbers come out as config.  I've searched and cannot find where anyone else has had this issue.  I have seen where there is a bug(s) with things in the toolbox but not anything dealing with the issue I'm having.  I have tried this in both SW2009, SW2010, 64bit and 32bit with the same results.

If I created them while in SW through the toolbox everything is good but I have too many that I need to do them one at a time.

Any help would be greatly appreciated.

Thanks

Ken

SolidworksToolbox