I have an NVIDIA Quadro K4000 GPU and I'm trying to open a 3.5GB assembly. The assembly can't make it past Generating Graphics. I have the preview part during load setting off, all of my drivers are SW recommended, and my GPU utilization never jumps above 5%. Could my processor or RAM be the culprit? I have 16GB DDR3 @ 1333MHz. My processor is an i5-4440 which is not good enough for what I'm doing but I have been told that the processor use should be low during the generating graphics process. Am I thinking correctly? Why can't i get past the generating graphics stage? Eventually the program crashes.

I just ran a benchmark test if the info helps:

Graphics...........8.9

Processor.......37.9

I/O..................21.4

Overall...........68.3

Rendering......72.5

Real View.........8.4

Simulation......77.2