Clipping algorithm error Unable to find a plane for projection

Hi, 
"Clipping algorithm error: Unable to find a plane for projection"
I get this error while running solidworks simulation. 
What does this mean?

Similar assembly which is fully defined,

applied loads properly.
Simulation runs well but not the present assembly.

Plz need help.

SolidworksSimulation
Answers 4
SY
SY 2021-04-08 Best Answer

any screen shots can post here for other to understand......please......

SA
SA 2021-04-08

Since last few assemblies I tried directly with Blended-Curvature based mesh & Course mesh. It worked.

But not the current one. Where I had this error.

Later I tried with standard default mesh. I worked well. I guess it was with Meshing.
So no issues now.
Thanks btw.

JR
JR 2021-04-08

Ditto what ‌ said but a pack-and-go might be better if you can share the model.

YZ
YZ 2023-01-27

I ran into the same error message with a beam-shell model.  It was fixed by using "standard" mesh.  NOT working when "blended curvature-based" is used.