Hello,

I am attempting to add the caterpillar feature to a drawing to provide a welding visual aid, but the partial length option is not available. I have used the feature before but I have not encountered this.

The screenshot shows my problem. I do not want the caterpillar to be on the inside of the circle. I also do not want the caterpillar I have applied to the circle to go through the sides of the small rectangles, but I am getting the same issue there. I have also pulled this view into an otherwise blank drawing and attached it below if that helps.

Has anyone seen this issue before? Any help you could provide would be appreciated.

Thanks!

Adam