Can't save library features

I did the following steps:

  • Close the sketch and do the following:

    1. Click the Design Library tab  to open the Task Pane.

    2. Click *the pin* to pin down the Task Pane, and select Design Library .

    3. Browse to folder where you want to add the library feature.

    4. Press Ctrl and in the FeatureManager design tree, select the features you want to save as a library feature.

  • [Do not include the base feature as a part of the library feature. If you include the base feature, the base will be part of the library feature (*.sldlfp) when you drag it to a model.]

      1. Hold down Ctrl, and drag the features to the lower panel of the Task Pane.

    I also tried:

    1.     Click the Design Library tab

    2.     Click 'Add to Library'

    3.     Select the feature to add

    4.     Name the feature

    5.     Click the green check mark

    Depending on which folder I choose to save the file in I either get this error:

    'Failed to save file'

    or

    it appears to save, but there is no feature in the library files.

    I did find a copy of the sldflp file located here:

    C:\\Program Files\\SolidWorks Corp\\SolidWorks\\Toolbox

    How do I move it so it shows up inn the task pane?

    Any suggestions?

    SolidworksParts And Features
    Answers 4
    GS
    GS 2010-03-16 Best Answer
    I'm not sure we are talking about the same thing, but if you want to save a sketch to use as a profile to extrude along a line as a structural member, here is how we do it.  Click on the sketch in the Feature Manager to highlight it, then go to File > Save As.  In the dialog box, choose where to save it as always, and choose Library Feature Part from the save as.. drop down list then click OK and it should be there.  I hope this helps.
    DG
    DG 2010-03-16

    Your methodology is OK but also make sure you have write access to Design Library folder. Change the design library path in Tools > Options > File Locations

    Alternatively cut/copy the file from C:\Program Files\SolidWorks Corp\SolidWorks\Toolbox and paste here C:\Program Files\SolidWorks Corp\SolidWorks\data\design library

    SF
    SF 2010-08-19

    Thanks for the answers.

    Deepak's solution worked perfectly.

    KL
    KL 2010-08-19

    Mark ... everything looks good except for step e).  There is no need to hold down the Ctrl key when dragging.