Hello,
I have made a drawing package that I need to pack and go so there are no references back to my current folder. My problem is when I do this my B.O.M that consists of hundreds of parts that I have organized and grouped on the original drawing, ungroups and reorganizes everything on the copied over drawing. I tried using Pack and go without adding a prefix and this works but it is no good because if you have 2 separate drawings open with the same part names they will reference each other still. Once I add the prefix I get the problems in my B.O.M. I just upgraded to SW 2011 hoping it may help but it didn’t. If anyone has a way around this error it would be much appreciated. Thank you
SolidworksBill Of Materials