Bend Flange with radius?


I am trying to create a simple part but I am unsure how create the flange how I like it to be. I want the bend to be closer to, if not flush to the flange below it. I attached the file which will make more sense.

There is a .060 gap currently I would like this to be no more than .010 if possible. How would I go about bending this flange to include the radius area?

SolidworksSheet Metal
Answers 8
JS
JS 2016-01-12 Best Answer

gm Keith -

Edit Sketch 13 then take a look

DG
DG 2016-01-12

Check if this helps.

DG
DG 2016-01-12

John, that part won't flatten.

JS
JS 2016-01-12

Does now - I had the bend relief with Tear rather than rectangle - thanks for the heads up

KR
KR 2016-01-12

Yes it does. Thank you. I have been trying to watch some closed corner videos on YouTube. But my Flash Player is being lazy...

Thanks again!

JS
JS 2016-01-12

The only thing I wanted to point out is that you can edit the edge flange, sometimes the close corner feature doesn't quite get what I needed, so I just edit the sketch.

DG
DG 2016-01-12

Agree that edit sketch is also a possibility but I just wanted to show one of under used feature

JS
JS 2016-01-12

No problem - I normally go that direction - but there are many different approaches - how about make a solid model, rip, create your own bend relief and then insert bends, that was a long time ago.....