Being Able to See SimulationXpress Calculations?

I'm looking for a way to verify SimulationXpress's accuracy, both by doing the calculations myself and seeing if Solidworks has some kind of built-in certification for its simulations. Is there a way to access either of these? I have Solidworks Basic, but I'd really like to be able to print off a calculations sheet for a simulation. The generated Word Docs don't include calculations, nor do the Edrawings.

Any help would be great, thanks.

SolidworksSimulation
Answers 8
SF
SF 2013-09-06 Best Answer

the verification and validation problems are in the help file. you can also do a search for the AFNOR document that has many more examples.

internal equations and calculations really can't be seen regardless of the product you have. you have the displacements, strains and stresses, so theoretically you could back calculate things if you wanted to. with the full sim product, you could ask the software for the .out file that has most of the matrices in it and do the calculation yourself.

that being said, i'd pick a few standard engineering problems, set them up and compare them. make sure you understand the assumptions that both methods make before you evaluate which one is "correct". 99% of the time, the lack of understanding the assumptions is what gets people tripped up between physical, calculation and FEA.

SF
SF 2013-09-09

Is the Help file in the file location specified in the settings before the Simulation is run? I believe the default is something like

"C:\Users\ENGINE~1\AppData\Local\Temp"? If so, most of those files are TMP's, which I haven't found a good way to read (I can open them in Notepad, but they just come out as computer text).

SF
SF 2013-09-09

not sure where you're going with that

a .out file can be output through the simulation settings in the full simulation only

SF
SF 2013-09-09

Oh, so I won't be able to access any of the validations and such without the full Solidworks simulation?

SF
SF 2013-09-09

the validation examples are in the help. they should be in all versions of the software. but it depends on what year of the software that you are using. i believe they were only added to the standard help (without simulation being enabled) in 2013.

SF
SF 2013-09-09

We use 2013, but the Solidworks Simulation tab in the Help bar isn't there, was that a recent update? If not then it may not be accessable in Standard.

SF
SF 2013-09-09

Thanks a lot for the help again, and thank you very much for the link!